| View previous topic :: View next topic |
| Author |
Message |
onedeadguy
Officially active!
Joined: 19 Jul 2010
Posts: 2
|
 Posted: Tue Jul 20, 2010 1:14 pm Post subject: WD2500JB Dead PCB # question. |
 |
|
Dead external drive. Fried Board. Found a replacement.
Possibly.
Number on my board is
2061-701292-C00 AB
Sellers board is
2061-701292-C00 AC
Is that good enough for a u12 switch? I would think so but i'm confused about the two letters at the end.
Thanks. |
|
| Back to top |
|
 |
|
|
harddrivespecialist
Deadharddrive regular +4
Joined: 29 Dec 2007
Posts: 471
Location: Providence, RI. Boston, MA USA
|
| Posted: Tue Jul 20, 2010 4:19 pm Post subject: |
|
|
Its good enough for ROM chip swap.
_________________
www.datarecoveryne.com |
|
| Back to top |
|
|
sunnydreamspace
Deadharddrive regular +5
Joined: 04 Jan 2009
Posts: 540
|
| Posted: Tue Jul 20, 2010 11:47 pm Post subject: |
|
|
hi,
you just matching 701292 will be fine. and for this kind of PCB. have ohters model for instead of. like 001292 it's same too. i often said for swap PCB no need to matching hard drive model or DCM any code. just matching PCB model(sometimes similar one will be fine.) here is my experience. please correct if i have any mistake(but without test i won't said anything)  thanks.
_________________
provide Hard drive PCB,entire drive/ Data Recovery service.... big HDD resource. talk to me immediately! sunnydreamspace@hotmail.com
skype: sunnydreamspace |
|
| Back to top |
|
|
sunnydreamspace
Deadharddrive regular +5
Joined: 04 Jan 2009
Posts: 540
|
|
| Back to top |
|
|
onedeadguy
Officially active!
Joined: 19 Jul 2010
Posts: 2
|
| Posted: Wed Jul 21, 2010 1:36 am Post subject: |
|
|
Thanks for the input guys. I went ahead and ordered the drive.
That video looks good Sunny. The only problem i have is the cost of the hot air solder gun. It's hard to find any for less than $90! I might end up attempting it with just a regular solder gun. |
|
| Back to top |
|
|
sunnydreamspace
Deadharddrive regular +5
Joined: 04 Jan 2009
Posts: 540
|
| Posted: Wed Jul 21, 2010 10:18 pm Post subject: |
|
|
hi,
be careful if you don't have experience on soldering operation. i recommend take it to repair shop fot it. just 30 second things and perfect. anyway good luck. any question ask before action.
_________________
provide Hard drive PCB,entire drive/ Data Recovery service.... big HDD resource. talk to me immediately! sunnydreamspace@hotmail.com
skype: sunnydreamspace |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
