| View previous topic :: View next topic |
| Author |
Message |
nan4k7
Posted once
Joined: 08 Aug 2007
Posts: 1
|
 Posted: Wed Aug 08, 2007 5:56 pm Post subject: Replacing Maxtor DiamondMax Plux 9 PCB |
 |
|
Hi people in this forum, I'm quite new. Been reading the forums but without registering and in this case I need your help.
I own a DiamondMax Plus 9 (80 gb) with the following characteristics.
| Quote: | YAR41VW0
E4FYA
PCB Called: Calypso III |
Because of a mistake, it was connected with the molex the wrong way and it never more started.
I really need the data stored in that drive so I acquired another HDD with the following characteristics
| Quote: | YAR41BW0
M6FYA
PCB Called: CALYPSO/KOI_P/THERM |
I changed PCB's and now the broken HDD starts but it's recognized by the BIOS as "Maxtor Calypso" and detects no capacity and everything is in 0.
Could anyone please tell me what to do? I can't buy logic cards from another place because I am from Argentina and they don't ship here...
Please... help me, I need the data stored on the broken HDD... |
|
| Back to top |
|
 |
|
|
spike_dball
Posted once
Joined: 11 Aug 2007
Posts: 1
|
| Posted: Sat Aug 11, 2007 10:43 pm Post subject: |
|
|
| From what I understand the difference in the 2 drives is in the size and number of platters. YAR41"V"W0 and YAR41"B"W0 although both are 80 GB V has more platters than B which has full size platters. |
|
| Back to top |
|
|
gsimon
Officially active!
Joined: 07 Sep 2007
Posts: 2
|
| Posted: Fri Sep 07, 2007 6:28 am Post subject: ... |
|
|
you must find hdd with the same code:
YAR41VW0
and to use pcb from that hdd.... |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
