www.deadharddrive.com

Mrsbusymomee · Active contributor Joined: 05 Jan 2011 Posts: 5

I'm currently in search of a WD10EACS - 00D6B0 was made May 6, 2008.
PCB is 2060-701537-004 REV A
PCB STICKER - 2061-701537-R00 AC

Hope someone can help!!

fzabkar · Deadharddrive regular +3 Joined: 02 Apr 2010 Posts: 210

If your drive spins up but is not detected, or its file system is reported as being damaged, as you have said in another post, then it's not a board fault. In any case, when swapping boards, you need to transfer the flash chip at U12, or its contents, from patient to donor. This chip stores unique, drive specific information. If location U12 is vacant, then the flash contents are internal to the MCU chip (the largest one).

Mrsbusymomee · Active contributor Joined: 05 Jan 2011 Posts: 5

[quote="fzabkar"]If your drive spins up but is not detected..."

This particular drive my 1TB, the PCB fried when the wrong power cord was plugged into it. It doesn't spin up.

My other post was pertaining to my 500GB which spins up, is recognized, but showing no data. The professional recovery place's diagnosis is a head crash problem. Don't you normally hear a sound or something when the drive spins up with a head crash problem? Confused

fzabkar · Deadharddrive regular +3 Joined: 02 Apr 2010 Posts: 210

An overvoltage on an external drive usually results in a shorted 12V protection diode, in which case the solution is usually an easy, no-cost DIY repair.

See this photo:
http://logiclevel.files.wordpress.com/2010/09/img_6063.jpg

TVS diode D4 is probably shorted, and resistor R64 may be open circuit. Examine your PCB and let us know what you find. If you have a multimeter (a cheap one costs US$10), measure the resistance of both components on the 200 ohms range.

As for your second question, a head crash would normally be associated with bad sounds from the drive. If the drive is in an external case, then it could be that your OS is detecting the USB-SATA bridge board inside the enclosure rather than the drive behind it.

sunnydreamspace · Deadharddrive regular +5 Joined: 04 Jan 2009 Posts: 540

i have this PCB in stock. i need do firmware transfer.

WD500 crash head. often will clicking(click 3 times around after stop motor) or just spin with normal sounds can read some data or some firmware(weak head)
you said it recognized. correct model? can you use MHDD for scan it?
_________________
provide Hard drive PCB,entire drive/ Data Recovery service.... big HDD resource. talk to me immediately! sunnydreamspace@hotmail.com
skype: sunnydreamspace

leon2046 · Deadharddrive regular +1 Joined: 27 Aug 2010 Posts: 29

you can refer to:

http://www.hddzone.com/wd-2060701537004-sata-l-model-pcb-p-185.html

Eric Lee · Posted: Sat Jun 11, 2011 2:14 pm Post subject:

Hi, We have this working PCB in stock, pls contact my hotmail to see if I can help or not.

Thanks
Eric
_________________
HK MingDi electronics Co., Ltd. http://www.hkmingdi.com/enindex.asp
MSN/E-mail：eric_lee8341@hotmail.com
Specialize in HDD PCB!!! Real in stock!!
Skype：eric.lee1984