www.deadharddrive.com

redemtionboy · Officially active! Joined: 10 Sep 2009 Posts: 3

Need the logic board for a Seagate Barracuda ST3250823AS Firmware 3.06

There was a short from a crappy power adapter I bought which caused this drive to continually trip the failsafe in my power supply. Hopefully the PCB board will be all that it needs.

sunnydreamspace · Deadharddrive regular +5 Joined: 04 Jan 2009 Posts: 540

hi,
please send high qulaity images of your PCB both side to me by email. i have lots of hard drive resource for sell and would like to help. thanks.
_________________
provide Hard drive PCB,entire drive/ Data Recovery service.... big HDD resource. talk to me immediately! sunnydreamspace@hotmail.com
skype: sunnydreamspace

Eric Lee · Posted: Fri Sep 11, 2009 2:31 am Post subject:

Hi,

Pls send your high quality picture to my hotmail too, I would like to see if I can help.

Thanks
Eric
_________________
HK MingDi electronics Co., Ltd. http://www.hkmingdi.com/enindex.asp
MSN/E-mail：eric_lee8341@hotmail.com
Specialize in HDD PCB!!! Real in stock!!
Skype：eric.lee1984

redemtionboy · Officially active! Joined: 10 Sep 2009 Posts: 3

Per request

harddrivespecialist · Posted: Fri Sep 11, 2009 12:24 pm Post subject:

Remove that burned chip on a top left corner and your drive should work.
Remember, if there is another short on your board, it might kill your preamp chip inside hdd. You should replace that TVS chip with another one.
_________________
www.datarecoveryne.com

redemtionboy · Officially active! Joined: 10 Sep 2009 Posts: 3

I don't think that chip is burned, it looks sorta like it in the picture, but doesn't in reality. Must be bad lighting. but if it is burned, where would I get that part? I do have a soldering iron.

harddrivespecialist · Posted: Sat Sep 12, 2009 3:54 pm Post subject:

test continuity on that chip, if its short, remove it.
_________________
www.datarecoveryne.com